Explore the ATmega328p Target Bd Microrusty

This board can be used for the following functions:

• Transfer program code to the ATmega328p microcontroller.
• Select the clock source and clocking frequency for the microcontroller.
• Read internal Flash program code and EEPROM content.
• Delete or erase program code. Clear data and reset back to default.
• Protect the chip against reading of its content.

Features:

• Arduino Uno pinout version with additional 5 volt and Ground for breadboard support.
• Operating/Input Voltage: 5 Volts Max. External Auxiliary input voltage jumper.
• Power on LED. No in circuit voltage regulator use external power regulator.
• Processor: ATmega328p, Atmega328P-PU 8 bit AVR family microcontroller.
• EEPROM 1K, SRAM 2K, Flash 32K
• Clock Speed: 16 MHz, 8 MHz, 1 MHz. Pins XTAL1 XTAL2 with 22pf to GND.

Pin Description

• Analog Input: 6 pins A0 – A5
• Digital IO: 14 pins D0 – D13
• PWM: 6 pins - D3, D5, D6 D9, D10, D11
• External Interrupt Pins D2 and D3: These pins can be configured to trigger an interrupt on a low value, a rising or falling edge, or a change in value.
• Built in LED Pin D13

Interfaces:

• RS232 Serial interface with 3 pin 1 UART. Serial Pins D0 (RX) and D1 (TX) GND: RX and TX pins are used to receive and transmit TTL serial data.
• J1 - ISP Interface. MISO, MOSI, SCK, Reset, VCC, GND
• SPI interface: Used for SPI communication. D13 SCK, D12 MISO, D11 MOSI, D10 SS
• TWI I2C. Used for TWI communication. A4 SDA, A5 SCL
• Reset Button: Push button to reset the microcontroller.

J7 AREF Not populated: To provide reference voltage for input voltage.

---

ATmega328p_Target_Bd_Microrusty.pdf

---

---