Complete the Schematic Layout

Adding the Crystal

1.  Open Schematic Layout Editor
2.  Select from Right Toolbar Place Symbol 
3.  Click Mouse on Grid (Symbols Libraries will load)
4.  Type in Search Field 9HT10
5.  Select 9HT10-32.768KBZF-T then click OK
6.  Place in Sector B1 Hit ESC Key.
7.  Select Annotate Icon from Upper Toolbar. Click on Annotate tab.
8.  Select Assign PCB Footprint to Schematic Symbol Icon from Upper Toolbar.
9.  After Footprints load select 9HT10-32.768KBZF-T  then select from Left Column 9HT10-32.768KBZF-T
10. Select Line item 3 Y1 - 9HT10-32.768KBZF-T :

Adding Resistors

1.  From Schematic Layout Editor
2.  Select from Right Toolbar Place Symbol 
3.  Click Mouse on Grid (Symbols Libraries will load)
4.  Type in Search Field R_Small_US
5.  Select R_Small_US then click OK
6.  Place in Sector B1 Hit ESC Key. Double click on text R_Small_US next to the symbol and change to 4.7K
7.  Hover over Resistor and hit the "c" to copy resistor. Repeat one more time for a total of 3 resistors 
8.  Select Annotate Icon from Upper Toolbar. Click on Annotate tab.
9.  Select Assign PCB Footprint to Schematic Symbol Icon from Upper Toolbar.
10. After Footprints load select Middle column R1 
11. Select from Left column Resistor_SMD.  Select from Right Column Resistor_SMD 1206 Hand solder  
10. Select OK 

Adding Capacitors

1.  From Schematic Layout Editor
2.  Select from Right Toolbar Place Symbol 
3.  Click Mouse on Grid (Symbols Libraries will load)
4.  Type in Search Field C_Small Footprint
5.  Select 'C_Small Footprint then click OK
6.  Place in Sector B1 Hit ESC Key. Double click on text C_Small Footprint next to the symbol and change to 0.1uF
7.  Hover over Capacitor and hit the "c" to copy Capacitor.  
8.  Select Annotate Icon from Upper Toolbar. Click on Annotate tab.
9.  Select Assign PCB Footprint to Schematic Symbol Icon from Upper Toolbar.
10. After Footprints load select Middle column C1 
11. Select from Left column Capacitor_SMD.  Select from Right Column Capacitor_SMD 1206 Hand solder  
10. Select OK 

Generate Netlist

1. From Schematic Layout Editor 
2. Select from Top Toolbar Generate Netlist 
3. From Popup select Generate Netlist 
4. Select Save

Now lets position the components on the PCB Component layout on PCB  

---